Table of Contents
Advertisement
(5) Performing re-sewing
Sewing can be performed without making the cloth open operation.
❶
(6) Performing threading
Turn OFF the power after carrying out the operation of step 1). Then, replace the needle, thread,
cloth cutting knife or knife holder.
❷
❶
1) Check that the pattern number is in the nor-
mal display.
If the pattern number is displayed with invert-
ed, press the presser switch to return it to the
normal display.
2) Press
3) You can start sewing with the presser switch
and start switch.
The cloth opening ON/OFF operation is not
carried out.
4) To release this setting, press
❶ .
to
If you do not want to activate the cloth cut-
ting knife, prohibit the knife operation in
accordance with
knife operation"
1) Press
in the normal display and the sewing machine
stops at the setting position.
① The needle bar turns to allow you to per-
form threading from the front side.
② The presser foot comes down.
③ The message "Press the RESET button"
is displayed.
In this state, buttons other than
are not accepted.
❷ to return ① to ③ to the previ-
2) Press
ous states.
The presser foot and the feed base oper-
ate. Be careful not to allow your hands or
fingers to be caught in them.
It is also recommended to install/remove
the presser unit after carrying out the
operation of the aforementioned step 1)
and turning the power OFF.
- 21 -
❶ to change over to
"6.(8) How to change the
P.22.
❶ when the pattern number is
.
to return
❷
Advertisement
Table of Contents
