Furuno GP-7000F Operator's Manual page 85

9.2.2 Sending/receiving routes data
You may sending/receiving routes as follows. When sending data, set the
connected equipment for receiving.
Note: All waypoints in a route can be transported with the route.
1. Connect the PC or another GP-7000/F to the equipment.
2. Choose INPUT/OUTPUT from the ADVANCED menu.
3. When sending data, follow steps shown below.
a) Choose NMEA 1 OUTPUT, NMEA 2 OUTPUT or RS232 3 OUTPUT
appropriately.
The sentence window appears.
b) Choose WPL and RTE sentences and then set these on.
4. When receiving data, follow steps shown below.
a) Choose NMEA 1 INPUT, NMEA 2 INPUT or RS232 3 INPUT appropriately,
and then push the [ENTER] knob.
b) Communication format between this unit and PC (or GP-7000/F) should be
the same.
5. Press the [CLEAR] key several times to close the window and menus.
6. Open the ROUTE LIST.
On WPL
GLL
On RTE
VTG
Off TLL Out
BWR
Off
DBT
Off
DPT
Off
MTW
Off
VHW
Off
WCV
Off
APA
On
APB
Off
HDG
Off
BOD
Off
XTE
Off
RMA
On
RMB
On
RMC
Off
GGA
Off
HSC
Off
AAM
Off
GTD
Off
MWV
Off
ZDA
Sentences window
9. DATA TRANSFER
On
On
On
9-5