Navigation Menu Installer / Manufacturer - Beretta POWER MAX Installation And Operation Manual

2.15 Navigation Menu INSTALLER / MANUFACTURER

It is necessary to enter the password to access the INSTALLER /
MANUFACTURER parameters
- Press "MENU/RESET" and select "Code" by using the "PROG
+" and "PROG -".
- Press "MENU/RESET" to confirm
- "0---" is displayed on the big numeric display and the first digit
is blinking
36
In this mode, keys have the following functions:
Nr.
1
2
3
4
5
1
2
Button Function
"+" Exits from the menu and cancels a parameter change
"-" Exits from the menu and cancels a parameter change
"PROG +" Selects the following menu or increases a certain parameter value
"PROG -" Selects the previous menu or decreases a certain parameter value
"MENU/RESET" Enters into the selected menu/parameter or confirms the parameter change
- Press "PROG +" and "PROG -" to increase or decrease the val-
ue of the first blinking digit
- When the desired value is reached on the single figure, press
"MENU/RESET" to confirm the inserted value thus the second
digit starts blinking
- Repeat the same procedure for all four figures and enter the
password
After entering the INSTALLER or MANUFACTURER password, the
related menu and parameters will be displayed.
The system provides for three types of access:
USER: password 0000
INSTALLER: password 0300
MANUFACTURER
b
After it is entered, the password is active during display and/
or parametrisation. If the display is inactive for a few minutes, it
needs to be re-entered.
RESET
PROG
MENU
3
4
5