Advertisement
65cm Basin Wash Stand
T49A CHR
Parts supplied:
Tools required:
(floor nipples)
2x
2x
6x
(rubber washers)
4x
Ø6.0mm
ST4.2 x 3.8mm
(floor nipple washers)
6x
1x
2x
2x
6x
1
2
3
Screw the legs into the rail.
Attach the two horizontal rails to the front rail.
Please note at this
step, if you are using
the regal designer
basin stand Extension
kit (T62). Then refer
to page 3 first, and
then go onto step 4.
1 - 3
C
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Burlington T49A CHR
Summary of Contents for Burlington T49A CHR
- Page 1 65cm Basin Wash Stand T49A CHR Parts supplied: Tools required: (floor nipples) (rubber washers) Ø6.0mm ST4.2 x 3.8mm (floor nipple washers) Screw the legs into the rail. Attach the two horizontal rails to the front rail. Please note at this...
- Page 2 Using a 6mm drill bit drill the six holes on the Check that the horizontal bracket bar is vertical Determine the final installation position and mark the 4 wall and two floor fixing hole positions in pencil. marked positions (note: In the event that the wall / using a spirit level.
- Page 3 Regal designer Basin Stand Extension Kit Parts supplied: Please refer to the basin stand instruction for the more detail basin stand installation. 845mm 785mm Without the Extention Kit With the Extention Kit 3 - 3...
Need help?
Do you have a question about the T49A CHR and is the answer not in the manual?
Questions and answers