Philips FC8820 Manual page 24

ENGLISH
24
Problem
The robot does
not start cleaning
on/off button.
E1 is on the
display.
E2 is on the
display.
E3 is on the
display.
E4 is on the
display.
E5 is on the
display.
E6 is on the
display.
The robot does
not clean properly.
Cause
The rechargeable battery is
empty.
The small plug is still inserted
in the socket on the robot.
One or both wheels are stuck.
One or both side brushes are
stuck.
The top cover is not present
or is not closed properly.
The bumper is stuck.
The robot was lifted while it
was cleaning.
The robot is cleaning a dark
the drop-off sensors. This
causes the robot to move in
an unusual pattern.
strongly. This triggers the
drop-off sensors and causes
the robot to move in an
unusual pattern.
The rechargeable battery has
not been inserted correctly.
The power switch is set to
'off ' while the robot is on the
docking station.
The bristles of one or both
side brushes are crooked or
bent.
Solution
Charge the rechargeable battery (see chapter
'Preparing for use').
The robot does not work on mains power.
the robot and the mains before use.
thread or wire that is caught around the wheel
suspension.
Clean the side brushes (see chapter 'Cleaning and
maintenance').
When the top cover is not present or is not
the top cover on the robot properly.
Press the on/off button to stop the robot.
Lift the robot so that its bumper comes free.
Press the on/off button to stop the robot.
Then press the on/off button again to make the
robot resume cleaning normally.
Press the on/off button and then move the robot
problem continues to occur on lighter coloured
the Consumer Care Centre in your country.
Close the curtains to block sunlight from entering
the room.
how to insert the rechargeable battery.
Set the power switch to 'on'.
Soak the brush or brushes in warm water for
See chapter 'Replacement' for instructions on
how to replace the side brushes.