induction cooKtoP inStALLAtion inStRuctionS
30" (76.2 cm) Min. Clearance
Between the top of the
Cooking Platform and the
Bottom of an Unprotected
Wood or Metal Cabinet
24" (61 cm) Min. when Bottom
of Wood or Metal Cabinet
is Protected by not Less
than 1/8" (0.3 cm) Flame
Retardant Millboard Covered
With not Less than no. 28
MGS Sheet Steel, 0.015" (0.4
mm) Stainless Steel, 0.024"
(0.6 mm) Aluminum or 0.020"
(0.5 mm) Copper.
* Letters on this figure refer to chart
on front page except for J and K.
to eliminate the risk of burns
or fire by reaching over heated surfaces,
cabinet storage space located above the
cooktop should be avoided. If cabinet
storage is provided, risk can be reduced
by installing a range hood that projects
horizontally a minimum of 5" (12.7 cm)
beyond the bottom of the cabinets.
Model and Serial number Location
the serial plate is located under the cooktop.
When ordering parts for or making inquires about
your cooktop, always be sure to include the model
and serial numbers and a lot number or letter from the
serial plate on your cooktop.
overhead Cabinet Should not Exceed a
Maximum Depth of 13" (33 cm)
2½" (6.4 cm) Min. From
Edge of Cutout to Front
Edge of Countertop
Figure 2 – countERtoP cutout oPEninG
Distance Between Rear
Edge of Cutout and
( 25.4 cm)
Approximate Location of
Serial plate is located
under the burner box
Min. From Edge of
Cooktop to nearest
(Either Side of Unit).
It is not recommended to use
drawer underneath cooktop.
Empty space is needed for
1 1/2" (3.8cm)