Ojmar LOCKR COMBI Quick Manual page 3

HOW TO CHANGE A CODE AND
SET LOCK MODE.
The lock has two operating modes:
1. Dedicated mode (F):
When set in this mode the code is fixed and the same code will be used to
open the lock each time.
HOW TO SET DEDICATED MODE
OPERATION.
In this mode the same code must be used when opening the lock.
1.
With the lock in the closed position ensure that the mode set screw on the
rear of the lock is turned to position R, see diagram below.
2.
Using the knob turn put the lock into the open position, with the blue arrow
vertical, see diagram below.
3.
Now set required private 4 digit code by turning code wheels. Remember
the code!
4.
Next turn the knob 90º left or right to the locked position according to the
hand of your lock. See diagram below:
5.
Now turn the mode set screw on the rear of the lock to position F.
The lock is now ready to be used in dedicated mode with the same code
being used every time to open the lock.
See diagram below:
2. Free mode (R):
When set in this mode the lock code can be reset by the user of the locker.
On vacating the locker a new user can set a new code once again.
Note: The lock is supplied from the factory with the code 0-0-0-0 and set in
Free mode.
Open Position
(Blue Indicator)
Right Hand Lock
Closed Position
(Blue Indicator)
Left Hand Lock
Fixed Position