Overview; Model List; Safety Precautions; For 1U Models - CyberPower PDU84001 User Manual

Overview

CyberPower Automatic Transfer Switches PDUs with dual input for power
provide redundant and increased reliability for critical devices with a single
power plug. Users can define the preferred input power source. When a
selected source is unstable or unavailable, the ATS PDU will switch to the
second power source to constantly provide power to connected devices. The
entire ATS PDU series are designed with LED and LCD interfaces for users
to easily observe power status and device load. On-site power management
is accomplished as users can configure power settings, via LCD interface,
according to local power condition. Available in both switched and metered/
monitored configurations, users have a broad base of options to select the
ATS PDU that best fits their needs.
WARNING: This automatic transfer switch has dual power cords (A & B) to
provide redundant power sources to devices with single power supplies and
can be plugged into separate compatible sources* to ensure continuous
access. Users select the preferred source as the primary input. CyberPower
Smart App Online and Sinewave series UPS are highly recommended for use
as the power source.
*Note: Only sine wave AC power sources are compatible with this ATS PDU.
Simulated sine wave AC power sources are NOT compatible.

Model List

Switched Metered by
Outlet Series
1U
PDU84001
PDU84002
PDU84004
PDU84005
PDU84006
PDU84301
Switched Series
1U
PDU44001
PDU44002
PDU44004
PDU44005
PDU44006
PDU44301
Metered Series
1U
PDU24001
PDU24002
PDU24004
PDU24005
PDU24006
PDU24301
*Selected models may not be available in certain regions. Please contact your
CyberPower sales team for more information.

Safety Precautions

Read the following before installing or operating the Automatic Transfer
Switches (ATS) PDU:
• Use only the supplied hardware to attach the mounting brackets.
• The ATS PDU must be plugged into a single phase three-wire, grounded
outlet on a circuit that is protected by a fuse or circuit breaker. For 15A
PDU series, please use a 15A circuit protector. For 20A PDU series, please
use a 20A circuit protector. For 30A PDU series, please use a 30A circuit
protector. Connection to any other type of power outlet may result in a
electrocution hazard.
• Do not use extension cords or adapters with these ATS PDUs.
• Never install an ATS PDU or associated wiring or equipment during a
lightning storm.
• Ensure that the power cord, plug, and socket are in good condition.
• For the ATS PDU with attached input Power Cords, the socket must be
installed near the equipment and must be easily accessible.
• Make sure to disconnect all power supply cords before attempting to
service or remove this unit.
• As for overcurrent protection, please be noted that all ATS PDUs with an
input current rating greater than 20A are equipped with two flush-mount
branch circuit breakers.
2U
PDU84003
PDU84007
PDU84302
2U
PDU44003
PDU44007
PDU44302
2U
PDU24003
PDU24007
PDU24302
Metered by Outlet Series
1U
PDU74001
PDU74002
PDU74004
PDU74005
PDU74006
PDU74301
Monitored Series
1U
PDU34001
PDU34002
PDU34004
PDU34005
PDU34006
PDU34301
1
2U
PDU74003
PDU74007
PDU74302
2U
PDU34003
PDU34007
PDU34302