Vitek VT-1609 Manual Instruction page 4

ENGLISH
Preparation for operation
• Unpack the unit.
• Before you connect the unit to the mains,
make sure that the voltage specified on
the unit corresponds to the voltage in your
home socket.
• Carefully wash all the removable parts,
which will contact with products, and dry
them.
Note: Be carefully while holding the
shredding sieve; its surface is very
sharp.
• Wash vegetables/fruits and cut them into
pieces, which will easily pass into the cov-
er throat of the unit.
• While extracting juice from stone fruits (for
instance cherry, peach etc.) remove pits
from the fruits.
Making juice
• Put the unit on the stable dry and flat sur-
face.
• Before assembling, make sure that the
unit is switched off and unplugged.
• Set the juice tank (5) on the motor unit (9).
• Set the shredding sieve (4) in the juice
tank (5), provided proper installation you
will hear a specific flick.
Note: - Do not use the shredding sieve if
it has any defects.
• Set the cover (3) on the juice tank (5).
• Set the juice container (8).
• Lift the clamp (7), and match it with the
groves on the cover (3).
• Put a container (11) or another vessel un-
der the pouring spout (6).
• Insert the plug into the socket.
• Switch on the juicer by setting the switch
(10) to the "I/low speed" position or to the
"II/high speed' position.
Note:
- "1/low speed" - is used to extract juice
from soft vegetables/fruits (tomatoes,
1609.indd 4 1609.indd 4
pears, strawberry, oranges, plums,
grapes, pumpkin, onion, cucumbers
etc.).
- "2/high speed" - is used to extract
juice from hard vegetables/fruits (ar-
tichoke, carrot, apples, pepper, beet-
root, potatoes, pineapples, vegetable
marrows, celery, spinage, dill, kurrat
etc.).
- the unit will switch on only if all the re-
movable parts are installed properly
and the upper cover is fixed by the
clamp (7).
• Put the products only while the motor is
operating.
• Gradually put preliminary cut pieces of the
products into the throat (2) of the cover
(3) and slightly press them with the pusher
(1). Do not press strongly the pusher; it
can lead to worse quality of the juice or to
a stop of the shredding sieve rotation (4).
• Do not immerse your fingers or other ob-
jects into the throat (2) of the cover (3).
• Periodically check the condition of the
shredding sieve (4) concerning blockage
of the filter, if necessary wash the shred-
ding sieve (4).
• Check the container (8), if it is full, switch
off the unit, take the plug out of the socket,
remove the container (8) and remove the
pressed skins.
• After using of the unit switch it off by set-
ting the switch (10) to the "0" position, wait
when the shredding sieve stops complete-
ly (4) and take the plug out of the socket.
• Dismantle and clean the unit each time af-
ter usage:
- Remove the pusher (1) from the throat (2).
- Pull the clamp (7).
- Remove the upper cover (3).
- Remove the juice tank (5) together with
the shredding sieve (4).
- Clean and wash all the details after usage.
ATTENTION: When making juice from "hard"
vegetables/fruits maximal operating time
should not exceed 1 minute, with the interval
4 4
08.06.2009 16:33:57 08.06.2009 16:33:57