To Close The Indoor Unit; Mounting The Outdoor Unit; About Mounting The Outdoor Unit; Precautions When Mounting The Outdoor Unit - Daikin Altherma 3 R F Installer's Reference Manual

7.2.6 To close the indoor unit

7.3 Mounting the outdoor unit

7.3.1 About mounting the outdoor unit

7.3.2 Precautions when mounting the outdoor unit

7.3.3 To provide the installation structure

ERLA11~16DAV3+W1 + EBVZ16S18+23DJ
Daikin Altherma 3 R F
4P643604-1 – 2021.09
1 Close the cover of the switch box.
2 Put the switch box back into place.
3 Reinstall the top panel.
4 Reinstall the side panels.
5 Reinstall the front panel.
6 Reconnect the cables to the user interface panel.
7 Reinstall the user interface panel.
NOTICE
When closing the indoor unit cover, make sure that the tightening torque does NOT
exceed 4.1 N•m.
When
You have to mount the outdoor and indoor unit before you can connect the
refrigerant and water piping.
Typical workflow
Mounting the outdoor unit typically consists of the following stages:
1 Providing the installation structure.
2 Installing the outdoor unit.
3 Providing drainage.
4 Installing the discharge grille.
5 Protecting the unit against snow and wind by installing a snow cover and baffle
plates. See "7.1 Preparing the installation
INFORMATION
Also read the precautions and requirements in the following chapters:
▪
"2 General safety
▪
"7.1 Preparing the installation
Check the strength and level of the installation ground so that the unit will not
cause any operating vibration or noise.
Fix the unit securely by means of foundation bolts in accordance with the
foundation drawing.
Use 4 sets of M12 anchor bolts, nuts and washers (field supply). Provide at least
150 mm of free space below the unit. Additionally, make sure the unit is positioned
at least 100 mm above the maximum expected level of snow.
4
site" [
precautions" [ 4 10]
4
site" [ 49]
7 Unit installation
|
49].
Installer reference guide
67