Winding The Power Cord - Fantom FM655CS Instruction Manual

PREPARATIONS BEFORE USE

WINDING THE POWER CORD

1
Hook the power cord over the clip
which is located on the upper
cord storage hook as shown.
Plug Side
Clip
THERMAL SAFETY DEVICE IN MAIN BODY
To protect your vacuum cleaner motor from overheating, a thermal safety device has been
built in. If your vacuum cleaner hose or air intake clogs up with dust or dirt, or if your dust
bag becomes full and you continue to run the machine, the vacuum will shut off
automatically to prevent the motor from overheating. If this happens, turn off slide switch
and disconnect your vacuum from power outlet, remove the material clogging the machine
and let your vacuum cool down for approximately 20 minutes. You can then restart your
vacuum cleaner and use it again.
INSERTING THE POWER CORD PLUG
WARNING: This appliance is equipped with a
grounded-type 3-wire cord (3-prong plug). This plug
will only fit into an electrical outlet made for a 3-prong
plug. This is a safety feature. If the plug should fail to
fit the outlet, contact an electrician to replace the outlet.
Do not attempt to defeat the safety purpose of the
grounding pin, part of the 3-prong plug.
2 Wind the power cord around
the cord storage hooks.
Secure the power
cord plug on the
power cord.
Cord Storage
Hooks
5