Table of Contents
Advertisement
P/N 0518258_C
P/N 0518258_D
a. To remove top rails, push rail toward
the back of the case with one hand
while lifting the top edge off the light
channel with the other hand. See
drawing below.
b. Starting at one end, carefully peel
bottom of top rail free of color panel
and set the rail inside the case.
c. Remove upper and lower bumpers by
pulling bumper away from bumper
retainers. Be careful not to lose the
internal joint trims on the upper
bumpers.
3. Starting at the left end of the line up,
install the upper bumper starter section
first. To install:
a. Position internal joint trims so that the
first is flush to the left-end panel and
the second is centered between the
starter bumper and the full length
bumper as shown below.
b. Install full length bumpers
and internal trims offset
across joints. Make sure
that no gaps exist between
sections. Continue
installing the upper
bumpers the length of the
line up. Do NOT install
the last upper bumper sec-
tion at this time. This sec-
tion will be installed in the
last step.
4. Install lower bumper starter and full length
lower bumpers by simply pushing them into
place. There are no internal joint trims on
the lower bumpers.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
Push
Pull
Step 2-b.
Starter
Bumper
Retainer
Internal Joint Trims
5. Return to the left end of
the line up and position
the starter section of the
top rail as shown.
NOTE: The top rail should not be installed
until the upper bumper is securely in place.
Push
Step 2-a.
Pull
Upper
Bumper
Internal
Joint Trim
Step 2-c.
Merchandiser
Joint
Full Length
Bumper
Medium Temperature
Produce & Bakery
1-7
1-7
Lift
Advertisement
Table of Contents
