Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for EcoxGear EcoRoam 30
Summary of Contents for EcoxGear EcoRoam 30
- Page 1 EcoRoam 30 Models: GDI-EXRMS300...320 User Guide...
-
Page 2: Quick Start
Search your Bluetooth Connection on your EcoRoam 30 by ECOXGEAR, a division of Smart Device Grace Digital Inc., San Diego, California. Designed and Engineered in the USA. Made in China. -
Page 3: Led Status Indicators
NOT remove the grill covers. LIMITED MANUFACTURER’S WARRANTY: The EcoRoam 30 is covered by a 1-year limited warranty that covers defects in workmanship and / or materials for a period of 1 year from original purchase date. This warranty does... -
Page 4: Standby Power
Control Buttons 2) Never use your ECOXGEAR if you have dropped it or thrown it against a hard & Operations surface which may have destroyed the integrity of the speakers, housings, or gaskets. In the event of a severe impact to... -
Page 5: Speaker Volume
Pairing Button accordance with any music or noise rules and regulations. This functionality is 2) Use the proper ECOXGEAR mounts if you ONLY available with two intend to mount the unit. 3) Properly seal the ECOXGEAR prior and after EcoRoam 30 units. Refer to... - Page 6 Please exercise care and good judgment when activated, the speakerphone using your ECOXGEAR speaker. Audio levels mic on your EcoRoam 30 will should be appropriate to your environment, comply with all local regulations, and always hear your voice commands...
-
Page 7: Battery Indicator
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov NOTE: There also are four LED WARNING: EcoRoam 30 has a built-in Battery Level Indicators located Lithium battery. The battery on the top of the unit. Each LED must NOT be used in or near an open heat source or represents 25% of a charge. -
Page 8: Set Up Recommendations
EcoRoam 30 without restriction. Before you power on your IC STATEMENT: EcoRoam 30, connect the USB This device complies with Industry Canada Micro port to the USB cable licence-exempt RSS standard(s). Operation is subject to the following two conditions:... - Page 9 OFF position, This equipment generates, uses, and can your EcoRoam 30 will not be able radiate radio frequency energy and, if not to turn on using the Standby installed and used in accordance with the instructions, may cause harmful interference Power Button.
-
Page 10: Optional Accessories
Bluetooth: Connect To Your AC (5V, 1A) USB Wall Outlet Smart Device & Play Audio Power Adapter When your EcoRoam 30 is turned For Mounting on, the LED Bluetooth Status Indicator on the top panel will Suction Cup Mount (¼” mount) -
Page 11: What's In The Box
Once connected, select and play your desired audio. Pairing Mode: If the LED is not flashing or if you wish to place your EcoRoam 30 in pairing mode, press and release the Bluetooth EcoRoam 30 User Guide button on the top panel. Your EcoRoam 30 shall announce, “Ready to connect”... - Page 12 Waterproof/Dustproof Rating open the Bluetooth Section within IP67 the device currently connected to the EcoRoam 30 and delete the Bluetooth connection. The EcoRoam 30 will then be available to pair & connect to an alternate Bluetooth enabled smartphone /...
- Page 13 Wireless Stereo Pairing Unit Weight 15 ounces of Two Speakers Output Power 15W Max Amp, x1 woofer (Ø3”) S/N Ratio 88dB +/- 3dB Power Source 3.7V, 2600mAh First Time Pairing Lithium Ion Battery Two Speakers: USB Input When you have two EcoRoam 5V, 1A 30 speakers and want to wirelessly pair them for stereo...
-
Page 14: Specifications
2.3” Re-Pairing Same Two Speakers After Already Paired Once: Power on the two EcoRoam 30 units. Wait approximately Mount Attachment Point 3-5 seconds and speakers will automatically re-pair to each other. The speakers will announce,... - Page 15 Important: Maintaining • Un-pairing the two speakers by pressing the Waterproofness Bluetooth Button will also Your EcoRoam 30 is only clear the Bluetooth pairing waterproof when the cap records on that speaker. is properly closed. In order • The pairing functionality is...
-
Page 16: Master Power Switch
Standby Button. The switch be controlled from the audio MUST be set to the ON position device when connected to the to power your EcoRoam 30. Once AUX-IN connection. the switch is set to ON, use the Input Standby Button located on the Connect the USB cable to the Top Panel to turn the unit On/Off.
Need help?
Do you have a question about the EcoRoam 30 and is the answer not in the manual?
Questions and answers