Table of Contents
Advertisement
Port Settings
9 HTTP Port
For configuring the HTTP port.
[Setting Values: R80 or 1025 to 65535]
9 RTSP Port
For configuring the RTSP port.
[Setting Values: R554 or 1025 to 65535]
9 TCP Port
For configuring the TCP port.
[Setting Values: 1025 to 65535 (R5678)]
9 UDP Port
For configuring the UDP port.
[Setting Values: 1025 to 65535 (R1259)]
9 Standard Protocol
Displays the Standard Protocol port number.
Memo :
Not changeable.
0
RTMP(S) Settings
9 First Stream
For configuring the RTMP(S) First Stream video.
Configure the setting to "on", select the checkbox
corresponding to the "Video" and "Audio" to be
streamed, followed by pressing the Save button.
RTMP(S) streaming will start after the camera is
restarted.
The default value is "off".
Memo :
The settings in [Video]-[First Stream] will be
0
applied as the video settings.
9 Second Stream
For configuring the RTMP(S) Second Stream
video.
Configure the setting to "on", select the checkbox
corresponding to the "Video" and "Audio" to be
streamed, followed by pressing the Save button.
RTMP(S) streaming will start after the camera is
restarted.
The default value is "off".
Memo :
The settings in [Video]-[Second Stream] will be
0
applied as the video settings.
9 MRL
For configuring the streaming server address for
the RTMP(S) First Stream/Second Stream.
[Default Value: rtmp://192.168.100.138/live/
stream0]
SRT Settings
9 SRT
Configuring it to "on" and pressing the Save button
starts SRT streaming after the camera is restarted.
9 SRT Mode
For configuring the SRT connection mode.
[Setting Values: RListener, Caller]
9 SRT Server
For setting the address of the SRT server.
The default value is 192.168.100.1.
Memo :
SRT Mode is configurable only when the setting
0
is set to "Caller".
9 SRT Port
For configuring the SRT port for use during live
streaming.
The default value is "4578".
9 SRT Encryption
For configuring SRT encryption.
[Setting Values: AES-256, AES-192, AES-128,
RNone]
9 SRT Password
For configuring the SRT password.
You can enter up to 10 to 15 characters.
9 SRT Bandwidth Overhead
Enter the SRT bandwidth overhead using an
integer between 5% and 100%.
The default value is "25%".
9 SRT Latency
Enter the amount of SRT latency using an integer
between 20 ms and 8000 ms.
The default value is "500ms".
9 SRT FEC
For configuring the FEC mode.
It enables recovery of data streaming packet loss
without retransmission.
[Setting Values: 6x6, 8x8, 10x10, ROff]
9 SRT StreamId
For setting the registered stream ID of the live
distribution destination. It allows direct streaming
of multiple cameras on a single device.
* You can enter up to 50 characters.
Memo :
Input and change are possible only when [SRT
0
Mode] is configured to "Caller".
31
Network
Advertisement
Table of Contents
