Nortel DMS-10 Quick Reference Manual page 18

10 Maintenance Commands
Command Name
BVALDTtt Changes the setting for the number of days
that a call record file is retained after it has
been polled.
tt - time (00-99).*
BVALDUE Examines the setting for the percent of total
disk drive capacity above which polled files
will automatically be deleted. Default value is
75.
BVALDUpp Changes the setting for the percent of total
disk drive capacity above which polled files
will automatically be deleted.
pp - disk capacity percentage (00-99).*
Note: Nortel recommends that the disk capacity percentage not be set
to a value greater than 85.
BVALIDE Examines the site identification and Switch-
ing System data.
BVALIDaabb Changes the site identification and Switching
System data.
aa - two-digit switch type
bb - two-digit site identification.*
BVALITE Examines the number of invalid blocks that
can be accepted by the BMC. Default value is
0000.
BVALITbbbbb Changes the number of invalid blocks that can
be accepted by the BMC.
bbbbb - invalid blocks (1-65,536).*
BVALPRE Examines the number of unpolled call record
file versions stored on disk before a Poll
Request message is issued. Default value is
25.
BVALPRff Changes the number of unpolled call record
file versions stored on disk before a Poll
Request message is issued.
ff - file versions (1-50). One-digit values need
HRBLKE Displays hour boundaries currently assigned.
Default value is 0024.
HRBLKssee Sets the time interval to verify that AMA
records have been received from the switch.*
ss - two digit start time: (00 - 23)
ee - two digit end time: (00 - 23).
Note: The following commands must be used while in the KYWD>
overlay.
KYWD Enters the KYWD> overlay.
L Examines the HOST password.
01Ciiiiii Changes the HOST password.*
iiiiii - six character HOST password.
297-6201-501 97Q3
Explanation
a space after the number (i.e., 4_).*
Standard 02.01 July 1997