Download Print this page

Balanced Body Metro IQ Quick Start Manual page 4

Advertisement

2. Pull the head end of the frame away from the headrest until it
is fully extended. Pull from center of the frame. You may need
to hold the carriage in place at the same time with your other
hand.
3. After fully extending the frame, flip the frame lock levers
closed to re-engage the frame locks on both sides of frame.
SHORTENING THE FRAME
1. To shorten the frame, flip the frame locks on both sides of the
frame open and push the head end of the frame toward the
head rest. Make sure the ropes and loops are out of the way.
2. Once the frame is fully collapsed, flip the frame lock levers
closed again to lock in place.
INSTALLING THE RISERS
1. Remove the locking pins from the frame. See figure F.
2. Insert the riser into the hole, angled out to the side as shown
in Figure G.
3. Re-insert the riser locking pin through the frame and the
risers.
Figure F
THREADING THE ROPES
1. With the frame extended attach springs so the carriage is
held in the home position.
2. Connect the ropes to the cotton loops and place the loops
over the shoulder rests.
3. Pass the rope through the riser pulley and back to the
carriage.
4
Figure G
IMPORTANT NOTE :
The rope must pass through the black eye strap, then the cam
cleat, and finally the other black eye strap. See Fig H.
To lengthen the rope, lift it out of the cam cleat, adjust to desired
length, and then push rope back into the cam cleat. To shorten
the rope, simply pull on the free end of the rope.
black eye strap
Cam cleat
Figure H
INSTALLING THE WHEELS
To install either wheel set make sure the Metro IQ is on the
ground and right side up. You may need to prop the frame up
with the packaging foam to give yourself easier access.
Metro IQ with Wheelbarrow Wheels (702-000)
1. Use the 5⁄32" Allen key to unscrew the two bolts next to the
footbar knobs on either side of the frame.
2. Place the bracket on the frame with the wheels facing inward
and the footstrap hole facng up. See Figure I.
Install using the screws
Figure I
3. Re-insert and tighten the bolts. Repeat on the other side.
Footstrap hole

Advertisement

loading