Advertisement
2. Slide a washer over a 6-32 screw and thread it into the hole
in the end of the knob post to secure the knob in place. See
Figure B.
Fender washer and screw
Figure B
3. Tighten with the 5/64" Allen wrench, and repeat on the other
side.
ATTACHING THE FRAME HANDLE
1. Insert the two large socket caps screws through the holes in
the handle and into the head-end of the frame. as shown (see
Figure C). Use the 3⁄16" Allen wrench to tighten the screws.
Figure C
INSTALLING THE SHOULDER RESTS
1. Shoulder rests get installed
with a threaded black knob.
Place the shoulder rests into
the notch in the carriage
head end and thread the
black knob. See Figure D.
Note: In order for the
shoulder rests to be
completely secure, the knob
has to be tightly threaded.
Note: The shoulder rests
can be installed in two positions. One position is wider and
more comfortable for broad shoulders. Swap the left and
right shoulder rests to change between standard and wide
configurations.
EXTENDING THE FRAME
1. Flip the frame lock levers on both sides of the frame open to
disengage the locks. See Figure E.
Closed (Locked)
Figure E
Re-install the
locking pin
Figure D
Opened (Unlocked)
3
Advertisement
