Seneca Z-MBus Installation Manual

Converter module

Table of Contents

Download this manual

From RS232 / USB to M-Bus (Meter-Bus)

Tel. +39.049.8705355 - 8705359 - Fax +39.049.8706287

For manuals in other languages and the configuration software, visit www.seneca.it/products/z-mbus

This document is the property of SENECA srl. Copies and reproduction are prohibited unless

authorised. The content of this document corresponds to the described products and technologies. Stated

data may be modified or supplemented for technical and/or sales purposes.

MI00516-2-EN

INSTALLATION MANUAL

Z-MBus

Converter module

Via Austria, 26 – 35127 – PADOVA – ITALY

SENECA s.r.l.

ENGLISH -1/1

Table of Contents

Need help?

Do you have a question about the Z-MBus and is the answer not in the manual?

Page 1 Tel. +39.049.8705355 - 8705359 - Fax +39.049.8706287 For manuals in other languages and the configuration software, visit www.seneca.it/products/z-mbus This document is the property of SENECA srl. Copies and reproduction are prohibited unless authorised. The content of this document corresponds to the described products and technologies. Stated data may be modified or supplemented for technical and/or sales purposes.
Page 2 MODULE LAYOUT 17.5 mm 111 mm Weigh 120 g. Case Materiale PA6, colore nero LED SIGNALS ON THE FRONT PANEL Status LED meaning ON  Device ON OFF  Device OFF Flashing  Transmission of data packet ON  Anomaly on the M-Bus (Meter-Bus) Flashing ...
Page 3 WARNING: The full content of this manual must be read before operation. The module must only be used by qualified electricians. Specific documentation is available at www.seneca.it\produtcs\z-mbus The word WARNING preceded by the symbol indicates conditions or actions that put the user's safety at risk.
Page 4 The M-Bus is a non-polarized bus. For the connection it is possible to use a two-wire shielded telephone cable or an unshielded duplex cable following the indications in the table. If a shielded cable is used this must be connected to earth only from the Z-Mbus converter side. CONTACT INFORMATION support@seneca.it...