Transponder Control; Status - uAvionix AV-30-C Manual

7.8 Transponder Control

When installed and configured, the AV-30-C can be used to control select
uAvionix transponders (including the BeaconX family). The transponder
controls are available on the Reversionary AI page in each mode.
The reversionary AI page is accessed by pressing and releasing the right
button repeatedly until AI appears in lower right corner of the display.

7.8.1 Status

The transponder control user interface, as presented on the reversionary
AI page, is shown below.
Figure 27 - Transponder Control
The current transponder status is indicated by the STAT field. The
following status annunciations may be displayed.
Status
.
OK
NOPOS
FAIL
TMOUT
MAINT
WAIT
FAULT
UAV-1003946-001, AV-30-C Pilot's Guide
Table 2 - Transponder Status
Status good, no fault
No GNSS position information, ensure clear sky view
Transponder device failure (broadcast monitor or transmission system)
Timeout, unable to communicate with transponder
Maintenance required, ensure proper configuration (e.g. ICAO address)
Retrieving configuration from transponder
Unknown or generic fault
A. Configured Callsign / Flight ID
B. Current Squawk
C. Mode Selection (STBY, ON,
D. GPS NIC (integrity
E. GPS NACp (accuracy
Pressure Altitude - Green indicates radar
F. interrogation and will change to IDT if
IDENT is
G. Transponder
Description
35
Code.
ALT).
metric).
metric).
active.
status.
.
Revision D
Page