Push-Set - uAvionix AV-30-C Manual

When installed as a non-required instrument (not replacing the existing
approved AI or DG), press and hold the center knob to switch between AI
and DG modes when the Function Lock feature is disabled. If the Function
Lock feature is enabled, then the pilot may not switch between modes.
See AV-30-C Installation Manual UAV1003947-001 for configuring the
Function Lock feature.

7.2 Push-Set

Activate the Push-Set window for accessing context menus and settings
by momentarily pushing and releasing the main rotary knob.
This activates a window along the bottom of the display to allow various
parameters to be adjusted with the rotary knob. Momentarily push and
release the knob to scroll through each option.
When you reach the option to change, rotate the knob to scroll through all
available values for this option. If the range setting has reached a limit, the
left or right indication arrows will indicate which direction the rotary knob
will change the setting. Both arrows indicate the setting can be increased
or decreased.
Momentarily push and release the knob to save the updated option value.
The settings window will disappear, and the new setting is saved.
The parameters that can be adjusted will vary, based on the
mode of the unit and the current configuration of the display.
Figure 6 shows how the barometric setting is adjusted when
altitude has been configured for display.
UAV-1003946-001, AV-30-C Pilot's Guide
Figure 6 - Push-Set Example – SET BARO
17 Revision D
Page