Table of Contents
Advertisement
Facings, gather hood and vents
Facings, gather hood and vents
Face the product only after having completed the
Face the product only after having completed the
following steps:
following steps:
• •
connection of the product to the smoke outlet and
connection of the product to the smoke outlet and
air intake;
air intake;
• •
inspection of the product when hot;
inspection of the product when hot;
• •
check to verify whether the product is levelled.
check to verify whether the product is levelled.
The installer must implement all the installation good
The installer must implement all the installation good
practices and take all the necessary precautions
practices and take all the necessary precautions
against overheating and fire.
against overheating and fire.
In particular:
In particular:
• •
if a plinth is constructed beneath the hearth level,
if a plinth is constructed beneath the hearth level,
it must include a suitable slot for the passage of
it must include a suitable slot for the passage of
recirculation air from the room;
recirculation air from the room;
• •
if the Air Diffuser Kit is installed, it must be possible
if the Air Diffuser Kit is installed, it must be possible
to inspect or replace the fans;
to inspect or replace the fans;
• •
wooden parts must be protected with fireproof
wooden parts must be protected with fireproof
panels, which must not be placed against one
panels, which must not be placed against one
another but spaced at least 1 cm apart to enable air
another but spaced at least 1 cm apart to enable air
to flow and prevent heat build-up. The gather hood
to flow and prevent heat build-up. The gather hood
can be made with fireproof panels, plasterboard
can be made with fireproof panels, plasterboard
or gypsum slabs; during construction, the hot air
or gypsum slabs; during construction, the hot air
ducting kit must be mounted as described above.
ducting kit must be mounted as described above.
The interior of the gather hood should be aerated
The interior of the gather hood should be aerated
14
by exploiting the flow of air coming from below (the
by exploiting the flow of air coming from below (the
space between the door and mantel) which convective
space between the door and mantel) which convective
currents will cause to exit from the grille on top,
currents will cause to exit from the grille on top,
thus allowing heat recovery and preventing undue
thus allowing heat recovery and preventing undue
overheating.
overheating.
In addition to that mentioned above, take into account
In addition to that mentioned above, take into account
the
the regulations in force in the relevant country
concerning "insulation, finishes, facings and safety
"insulation, finishes, facings and safety
recommendations".
recommendations".
Vents
Vents
These must be strictly installed on the front: one
These must be strictly installed on the front: one
beneath and one above the fireplace's opening. The
beneath and one above the fireplace's opening. The
product is not supplied with.
product is not supplied with.
INSTALLATION
FRAME (OPTIONAL)
FRAME (OPTIONAL)
The inlet surround is an optional accessory.
It fills in the gap remaining between the firebox's
frame and the cladding itself.
Advertisement
Table of Contents
