CAUTION
Step 7. On the Processor Extender Board, set the IPF/PA switch to the IPF position. Refer to Figure 2-4,
"Processor Extender Board Switches."
Figure 2-4 Processor Extender Board Switches
Enabling the Onboard VGA
To enable the onboard VGA, perform the following steps:
Chapter 2
Do not overtighten the 6 shoulder screws—they may shear off if overtightened. Stop
tightening the shoulder screws when you feel them just bottom out.
Upgrade Procedures for 1.3 GHz (A7158A) or 1.5 GHz (A7159A) Processors
Set switch to IPF
Introduction
31