Figure 3-3 Installing Processor On Extender Board - HP 9000 rp4440 Upgrade Manual

Upgrade Procedures for 1.1 GHz mx2 Dual Processor Modules (A9730A)
Introduction

Figure 3-3 Installing Processor on Extender Board

Tightening sequence for 4-shoulder
screws is:
1,2,3,4,5,6
DO NOT OVERTIGHTEN!
1
3
Align pins on
heatsink
with slots
Step 7. Use a long flat blade screwdriver to tighten screws 5 and 6 shown in Figure 3-3, "Installing
Processor on Extender Board."
42
4
2
6
slots*
slots*
5
cable protected by plastic
sleeve
Torx-T15
Use supplied
wrench for
tightening
shoulder screws
and thumbscrews
2.5MM Allen
Power
*slots shown are at
CPU socket #1 for
clarity.
Processor shown is
being mounted on
socket #0 per CPU load
order.
Chapter 3