Related Manuals for Argos Home Arlon 452/8454
Summary of Contents for Argos Home Arlon 452/8454
- Page 1 Arlon 452/8454 Spare Parts Customer Support Visit: www.argos-support.co.uk Call: 0345 640 2020 Email: Help@ClickSpares.co.uk Call: 0330 016 1114 Issue 2 - 16/12/19...
-
Page 2: Care Advice
Safety Important - Please read these instructions fully before starting assembly • WARNING: To prevent • Warning: This unit weighs possible overbalancing this unit approximately 34kgs. must be secured to a wall using Please lift with care. the 2 overbalance protector kits •... -
Page 3: Cabinet Panels
Cabinet Panels 2 71 x 56.4cm 3 71 x 56.4cm 1 71.4 x 58cm 5 75.6 x 28cm 6 37.1 x 6cm 7 37.1 x 9.2cm 4 119.8 x 58.6cm 8 37.1 x 56.2cm 9 37.1 x 56.2cm 10 44.9 x 39.5cm 11 39.7 x 65.6cm Drawer Panels Note: the internal drawer panels are grey... - Page 4 Fittings Use these drawings to correctly identify the fittings Bag 1 x 16 x 16 x 20 x 14 Bag 2...
- Page 5 Fittings Use these drawings to correctly identify the fittings Tools Only used for drilling walls...
- Page 6 Fitting Ball Bearing Runners www.youtube.com/watch?v=yG4xtiJJeSg Bag 1 x 16 x 16 x 20 x 14 2nd hole Finished front edge Finished front edge 2nd hole...
- Page 7 Finished front edge Finished front edge Finished front edge Finished front edge Finished front edge Finished front edge...
- Page 8 Finished front edge Hinge Fixing and Door Adjustment www.youtube.com/watch?v=wIMhUHeLBtg Finished front edge Finished front edge...
- Page 9 Finished front edge Finished front edge Finished front edge...
- Page 10 Finished front edge...
- Page 11 Finished front edge Finished front edge...
- Page 12 Finished front edge Finished front edge Finished front edge...
- Page 13 Finished front edge Note: Support this panel until the end panel is fitted in the next step. Finished front edge...
- Page 14 Finished front edge...
- Page 15 Squaring up a Chest and fitting the Back Panel www.youtube.com/watch?v=FeaI6541z7o Make sure measurement A and B A = B are the same before fixing the Back panel in the next step x 14...
- Page 17 WARNING! In order to prevent overturning this product must be used with the wall attachment device provided See the next section for a guide to wall mounting and fixings Example s t y Washer Screw Washer Wall fixing (not supplied) Screw (not supplied) To prevent possible overbalancing this unit must be secured to a suitable wall by fitting of...
-
Page 18: A Guide To Wall Mounting & Fixings
A Guide to Wall Mounting & Fixings Important: When drilling into walls always Important note: check that there are no hidden wires or pipes etc. If plastic wall plugs Make sure that the screws and wall plugs being used are supplied with your are suitable for supporting your unit. - Page 20 Hinge Fixing and Door Adjustment www.youtube.com/watch?v=wIMhUHeLBtg...
- Page 21 Hinge Fixing and Door Adjustment www.youtube.com/watch?v=wIMhUHeLBtg Note: The easiest way to attach the Door is to fit the top Hinge first, then align and fit the other Hinge. Push the Hinge onto the front part of the Hinge Plate. The recess at the bottom of screw B goes into the slot in the Hinge Plate. Keep the Hinge FLAT against the Hinge Plate as you slide it across as far as it will go.
- Page 22 Hinge Fixing and Door Adjustment www.youtube.com/watch?v=wIMhUHeLBtg Adjust the Door if needed Before adjusting the Door, use a Spirit Level to check the Top (or Base) of the unit is level, front-to-back and side-to-side in the 3 positions shown. Use suitable packing pieces (not supplied) to make the unit level BEFORE making any adjustment to the Hinges, as shown.
-
Page 23: Drawer Assembly
Drawer Assembly Bag 2 Drawer Assembly www.youtube.com/watch?v=InNBV_uuMmo... - Page 26 Fitting Ball Bearing Runners www.youtube.com/watch?v=yG4xtiJJeSg Warning: Use a screwdriver to position the runners as they could have sharp edges Fit the Drawer by sliding both its runners forward and locate the drawer sides between them, lining up the holes in the drawer sides with the 2nd 'threaded' holes in the runners. Working from the inside of the Drawer, insert 2 screws through the drawer sides and out into the 2nd threaded hole in the runner.
- Page 28 ALR3614...
Need help?
Do you have a question about the Home Arlon 452/8454 and is the answer not in the manual?
Questions and answers