Battery (Electric Start) - Arctic Cat BlastZR/LT/M-4000 Operator's Manual

5. While holding the cable housing,
lightly pull on the cable end to remove
any slack; then measure the amount of
exposed cable from the cable housing
to the end of the cable (cable drum).
APV CABLE LENGTH
36.5 mm ± 1 mm

NOTE: The measurement must be
within the specifications from the
chart. If the measurement is within
specifications, no adjustment is nec-
essary (proceed to step 8). If it is not
within specifications, proceed to
step 6.
6. Loosen the jam nut on the cable;
then using the adjusting nuts,
lengthen or shorten the housing as
needed.
7. Once the proper length has been
attained, hold the adjusting nut in place
and tighten the jam nut securely.
8. Place the cable housing into position
in the servomotor. Secure the cable
housing with the cable holder.
CAUTION
Ensure the cable is rotated and
secured properly to avoid contacting
exhaust components.

Battery (Electric Start)

These sealed batteries after being in ser-
vice require regular
recharging in order to deliver peak per-
formance and maximum service life. The
following procedures are recommended
for cleaning and maintaining sealed bat-
teries. Always read and follow instruc-
tions provided with battery chargers and
battery products.
26

be done by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
This service is at the discretion and
expense of the snowmobile owner.
To remove and charge the battery, use the
following procedure:
Improper handling or connecting of a
battery may result in severe injury
including
burns, or blindness as a result of an
explosion. Always remove rings and
watches. Any time service is per-
formed on a battery, the following
0735-516B
must be observed: keep sparks, open
flame, cigarettes, or any other flame
away. Always wear safety glasses.
Protect skin and clothing when han-
dling a battery. When servicing a bat-
tery in an enclosed space, keep the
area well-ventilated.
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the
state of California to cause cancer
and reproductive harm. Wash hands
after handling.
cleaning and
NOTE: Battery maintenance may
! WARNING
acid
! WARNING
1. Remove both access panels and the
hood.
2. Remove the springs securing the res-
onator and the expansion chamber;
then disconnect the temperature sen-
sor from the main harness. Remove
both the expansion chamber and the
resonator.
burns, electrical
ZR-387