BRAYER BR4204 Instruction Manual page 10

10 EN
• Install the dust bin (11) back to its place and make
sure that the dust bin (11) is fixed properly.
Cleaning the filters installed in the dust bin (11)
• Preliminarily remove dust and garbage from the dust
bin (11) as described above.
• Turn the upper lid (16) clockwise.
• Remove the inlet filter (26).
• Remove the foam filter (25).
• Remove the cyclonic filter (24) from the dust bin flask
(11).
• Clean the cyclonic filter (24) from dust and garbage.
• Wash the elements of the cyclonic filter (24) under
warm water jet and then dry them.
• Wash the foam filter (25) and the filter (26) under
warm water jet and then dry them.
• Do not wash the parts in a dishwashing machine.
• Thoroughly dry the foam filter (25) and the filter (26).
• Do not dry the foam filter (25) and the filter (26) with
a hairdryer or other similar appliances.
• Wash the dust bin flask (11), wipe it and dry it.
• Insert the cyclonic filter (24) into the dust bin flask
(11), insert the foam filter (25) and the filter (26) into
the cyclonic filter (24).
• Install the lid (16) and turn it clockwise as far as it
will go.
• Close the lid (22) until the lock (21) catches.
• Install the assembled dust bin (11) back to its place,
make sure that the dust bin (11) is fixed properly.
Attention! Before assembling and installing the dust bin
(11) back to its place make sure that the cyclonic filter
(24), the filters (25, 26) and the flask are dry.
Cleaning the motor filter
• Remove the dust bin flask (11), take out the motor
filter and clean it (fig. 6), then install the motor filter
back to its place.
Cleaning the outlet HEPA filter
• Switch the vacuum cleaner off and unplug the power
cord plug from the mains socket.
• Remove the outlet filter grid (19) by pressing the lock
(25) and remove the outlet filter.
• Wash the outlet HEPA-filter and the grid (19) under
a lukewarm water jet. Do not wash the outlet HEPA-
filter and the grid (19) in a dishwashing machine.
• Dry the outlet filter and the grid (19).
• Do not dry the HEPA filter with a hairdryer or other
similar appliances.
• Install the outlet filter back to its place.
• Install the grid (19) back to its place, Make sure that
the grid (19) is securely fixed with the lock (20).
Vacuum cleaner body
• Clean the vacuum cleaner body with a soft, slightly
damp cloth, and then wipe it dry. Provide that no
liquid gets inside the vacuum cleaner body.
• Do not use solvents or abrasives for cleaning the
vacuum cleaner body and the attachments.