Table of Contents
Advertisement
2-2
ADJUSTING THE PROJECTOR IMAGE
2-2-1
ADJUSTING THE PROJECTOR HEIGHT
1.
Press the Elevator buttons. (Drawing 9 and
10)
2.
Raise the projector to the desired display
angle, allowing the legs to extend, and then
release the buttons to lock them in position.
3.
Use the Adjustable foot (Drawing11) at the
rear of the unit to fine-tune the display
angle.
4.
Use the Keystone key on the Remote
Control or in the OSD to correct any
distortion caused by tilting the projector.
(Drawing12)
Increase (+) Keystone value
Decrease (-) Keystone value
2-2-2
ADJUSTING THE PROJECTOR ZOOM/FOCUS
Adjust the Zoom ring to adjust image size.
Rotate the Focus ring to focus the image. The
projector will focus at distances from 1.5m
(60in. / 5 ft.) to 10m (394 in. / 32.9 ft.). The
optimum distance is from 1.5 m to 5 m (197 in.
/ 16.5 ft.).
DRAWING 12
INSTALLATION
DRAWING 9
Elevator Button
DRAWING 10
Elevator Button
DRAWING 11
Elevator foot
Adjustable foot
DRAWING 13
Zoom Ring
Focus Ring
Advertisement
Table of Contents
