Christie Roadster S+12K Replacement Instructions Manual page 3

+
S 12K / 14K / 16K / 20K Lamp & Filter Instructions
STEP 5 - REMOVE THE LAMP MODULE
Firmly grasp the handle and pull the lamp module straight out of the projector, as shown in
Figure 3. Discard the lamp using safe disposal/recycling practices.
Figure 3. Remove Lamp Module
STEP 6 - INSERT THE NEW LAMP MODULE
WARNING
Improper installation could cause a
serious meltdown inside the projector.
NOTE
The lamp module must make full contact with the lamp connectors.
Increased resistance indicates initial contact with the connectors –
push firmly at this point to make full contact.
Align the base plate of the new lamp module under
both side alignment guides. Refer to Figure 4. Slide
the module fully into the projector in the same
orientation the old lamp module was removed.
Push with normal force until the resistance
increases and then firmly push the module another
½ inch.
Figure 4. Alignment Guides
013-100049-03 (Rev.1) 3 of 8 Pages