Siemens SITRANS FCT030 Quick Start Manual page 10

Signal input Start dosing, stop
dosing, reset tot.
Passive
1, reset tot. 2,
reset tot. 3, reset
all totalizers, start
zero point
adjustment,
pause/resume
dosing, force
output, or freeze
output
Relay output Alarm class, alarm
number, one-
stage dosing, or
two-stage dosing
Relay output Alarm class, alarm
number, one-
stage dosing, or
two-stage dosing
Note
Load
Signal output: < 500 Ω
Relay output: 30 V AC/DC, 100 mA
Connection check-up
1. Check individual wire installation by tugging firmly.
2. Firmly tighten cable glands and insert blanking plugs in unused cable entries.
3. Remove o-ring from lid.
4. Reinstate lid and screw in until mechanical stop. Wind back lid by one turn.
5. Mount o-ring by pulling it over the lid and tighten lid cover until you feel friction from the o-ring on both sides. Wind lid by
one quarter of a turn to seal on the o-ring.
6. Reinstate and tighten lid lock screw where supplied.
7. Ensure that moisture does not penetrate to inside of electronics housing by creating a drip loop (bend cables downward)
immediately before cable glands.
10
X X
X X
Normally open
X X
Normally closed
IOXp- IOXp-
IOXC IOXC
+
-
IOXa+ IOXa+
IOXp- IOXp-
IOXC IOXC
IOXa+ IOXa+
IOXp-
IOXC
IOXa+
SITRANS FCT030 transmitter
A5E03922778-01, 03/2012