Specifications
Environment
Component (YPbPr) video. Composite video.
Devices
DVD, VCR, TV, satellite receivers, monitors,
switchers, home theatre and other equipment
supporting component video.
Transmission
Transparent to the user.
Bandwidth
Video: DC to 8 MHz.
1.1Vp-p
Maximum Input
Insertion Loss
Less than 2 dB per pair over the frequency range
from DC to 8 MHz
Return Loss
Greater than 15 dB over the frequency range from
DC to 8 MHz
Greater than 40 dB @ 8 MHz
Common Mode
Rejection
Max. Distance Color –
Component (YPbPr): 1,000 ft (305m).
Cat 5 UTP
Composite: 2200 ft (670m)
24 gauge or lower solid copper twisted pair wire
Cable – UTP
impedance: 100 ohms at 1 MHz
Maximum capacitance: 20 pf/foot.
Attenuation: 6.6 dB/1000 ft at 1 MHz
Cable – BNC
Impedance: 75 ohms at 1 MHz
One (1) gold-plated RCA connector
Connectors
Reverse polarity sensitive
Two (2) screw terminals for twisted pair
Impedance
Input: 75 ohms unbalanced (RCA connector)
Output: 100 ohms balanced UTP (screw terminals)
Operating: 0° to 55°C. Storage:-20° to 85°C.
Temperature
Humidity: up to 95%
Enclosure
ABS fire retardant plastic
Dimensions
1.25" x 0.5" x 0.5" (3.2 x 1.3 x 1.3 cm)
Weight
1.5 oz (42.5gm)
*Specifications subject to change without notice.
2222 Pleasant View Road, Suite #1
Middleton, WI 53562
Tel.: (608) 831-0880
Fax: (608) 831-1833
Toll Free (N.Am): 866-4-MATMIX
E-mail: intelix@intelix.com
URL: www.intelix.com
Intelix LLC
V1-CV Component Video Balun
Installation Guide
Introduction
The Intelix V1-CV Component Video Balun allows a single component video signal
(Y, Pb, or Pr) to be transmitted via cost-effective unshielded twisted pair (UTP)
cable. Three (3) balun pairs are required for one point-to-point component (YPbPr)
video connection. The product allows three coaxial cables to be replaced by one
Category 5 twisted pair cable allowing standard structured cabling techniques to be
used for neater and more streamlined cabling. The V1-CV is compact enough to
allow three (3) units to be connected side by side on the back of the component
video equipment.
Installation
Component Video (YPbPr) Connection:
Three (3) pairs of Component Video Baluns (six baluns) are needed to complete one
component (YPbPr) connection via Cat5 twisted pair. To install V1-CV baluns, perform
the following steps:
1.
Identify the pin configuration of the baluns. One twisted pair is required. The
V1-CV is reverse polarity sensitive. Please ensure that wiring is straight-
through (Ring to Ring, Tip to Tip)