4. Wiring (inside the electrical equipment rack)
[Standard type and the laser type]
⑥
⑥
1) Connect AT solenoid cable ② and AT SOL cable asm. A ⑦ to the AT SOL PCB asm. ⑥ in the elec-
trical equipment rack.
IN4/IN5/IN6
2) Insert the pin contact of the black wire (GND) of AT SOL cable asm. A ⑦ into IN6/IN7 connector pin
No. 4.
3) Connect AT SOL cable asm. A connector ⑦ to the loose line / LOOSE connector of the electrical
control box.
4) Pull AT solenoid cable ② into the electrical
equipment rack through cable entrance of the
rack.
②
②
Pin No. 10
– 6 –
⑥
⑥
⑦
⑦
GND
LOOSE
24V
Loose thread