JUKI PS-800-12080 Instruction Manual page 6

E retaining ring
E retaining ring
End A
Mounting hole
Retaining ring
of the thread
Grease
tension con-
application
troller asm.
points
Spring
End B
4) Secure AT solenoid asm ② in the
mounting hole with screws ⑤ (two
pieces).
5) Put a little amount of grease (white) sup-
plied in the accessory bag on a piece of
cloth. Then, apply a thin coat of the grease
to the AT shaft, reseat spring and tension
release pin with that cloth.
6) Put the end A of tension release auxiliary
shaft asm. ① into the thread tension con-
troller mounting hole.
Put spring ④ on the end B of the tension
release auxiliary shaft asm.
– 4 –