Silent Mode - Directed Electronics 600 ESP Owner's Manual

Directed electronics model 600 esp security system owner's guide

Table of Contents

and know where the Valet

the installer for the location of the Valet

To disarm the security system,

turn the ignition to the "on"

position. Press the Valet

the pre-programmed number of

times (1-5 times) within 15

seconds. The system should now

disarm. If it does not, you may

have waited too long, so turn

the ignition off and on and try

again.

IMPORTANT! The unit can be programmed to respond to 1-5 pulses of

the Valet

switch for the disarm function. Be sure to check with the

installer for the desired programming.

Silent Mode

To temporarily turn off the arm or disarm chirps, use Silent Mode

Simply press

briefly before arming or disarming, and the

confirmation chirp(s) will be eliminated for that one operation

only. If you want the arm/disarm chirps turned off permanently,

your dealer can do this for you.

NOTE: The Warn Away

tem is armed using Silent Mode. This ensures that no chirps will be emit-

ted by the siren in an area you want chirp-free. The system is still fully

capable of triggering. Only the Warn Away response is bypassed.

1999 Directed Electronics, Inc.

switch is located. Be sure to check with

switch.

switch

response to lighter impacts is bypassed if the sys-

DRW-35

™

Table of Contents