Legacy Flexzilla L1355FZ Owner's Instructions page 2

Grease Gun Terms
Follower Rod
Bleeder Valve
Bleeds air without
disconnecting barrel.
Troubleshooting Your Grease Gun
Problem
Grease does not flow when handle is stroked.
Grease leaks between gun head and extension or
extension and coupler.
Grease leaks from coupler body joint or between
coupler jaws and grease fitting.
Warranty
LEGACY MANUFACTURING COMPANY ("LEGACY") warrants that this equipment will be free from defects in material and workmanship for a period of one (1) year from the date of
purchase, under normal use. LEGACY'S sole obligation under this warranty is limited to replacing or repairing, free of charge, any equipment that proves to be defective under normal
conditions and use according to the recommendations of LEGACY. To obtain repair or replacement, the equipment must be shipped to a LEGACY authorized Warranty and Service
Center during the warranty period, transportation charges prepaid, with proof of date of purchase. In the event of repair or replacement, the warranty period shall not be extended
beyond the original warranty period. While necessary maintenance or repairs on your Legacy equipment can be performed by any company, we recommend that you use only
authorized Legacy service centers. Improper or incorrectly performed maintenance or repair voids this warranty. Contact us at service@legacymfg.com or
www.legacymfg.com/instruction-manuals/ for installation instructions.
Piston
Handle
End Cap
Filler Nipple
Permits gun to be
reloaded without
disconnecting barrel.
Cause(s)
Gun needs to be re-primed
Grease cartridge is still capped
Grease cartridge or barrel is empty
Blocked Grease Coupler
Blocked Grease Extension
Threads need to be sealed
Damaged coupler
Damaged grease fitting
Attachments
(Installed hardware varies by gun)
Linkage
Gun Head
Barrel
Remedy
See "Re-Priming Your Grease Gun"
• Check to ensure caps have been removed from both
• Insert new cartridge or fill barrel
• Prime gun
• Remove coupler and pump grease
• If grease flows without coupler, clean or replace
• Remove extension and pump grease
• If grease flows without extension, clean or replace
Apply thread sealant
Replace coupler
Replace fitting
Coupler
Grease Hose or
Rigid Extension
ends of cartridge
extension
extension