Advertisement
Quick Links
#796 CIRCULATING FAN KIT
INSTALLATION and OPERATING INSTRUCTIONS
Canadian and American Gas Association approved for use only with
1. DESCRIPTION OF SYSTEM
The Valor Legend Ultra Model 737 has been designed to accommodate the
installation of an air circulation fan. Operated by a hi/ lo/ off fan control and
a thermally actuated switch, it is designed to boost the natural convection
f i r e - p a r t s . c o m
process through the heater, this may be a desirable feature dependent on the
fireplace location and room layout. The circulating fan may be installed
before the heater installation or as a retrofit at a later date.
2. ELECTRICAL REQUIREMENTS.
The fan kit requires a power supply of 120 Volts, 1 phase, 60 Hz. Full
load current is less than 1 amp.
This power supply must be installed and grounded in accordance with local
codes, or in the absence of local codes, with the current Canadian
Electrical Code CSA C22.1. or in the USA the National Electrical Code
ANSI/NFPA70 latest edition.
3. FAN KIT COMPONENTS
The complete #796CFK Kit contains the following:
•
Fan /Motor c/w mounting plate,
wiring harness c/w thermal switch
and Molex connector.
•
Hi/ Lo/ Off controller/ junction box
c/w Molex receptacle and 6' cord
set.
VALOR LEGEND ULTRA MODEL 737X
Page 1 of 5
•
Right hand heat baffle
•
Left hand heat baffle
•
Control mounting bracket
•
Screw and cable tie package
DECEMBER 1999
Advertisement
Related Manuals for Valor 796
Summary of Contents for Valor 796
- Page 1 VALOR LEGEND ULTRA MODEL 737X 1. DESCRIPTION OF SYSTEM The Valor Legend Ultra Model 737 has been designed to accommodate the installation of an air circulation fan. Operated by a hi/ lo/ off fan control and a thermally actuated switch, it is designed to boost the natural convection f i r e - p a r t s .
-
Page 2: Installation
4. INSTALLATION • Remove the heater inner front and front frame in sequence and set aside. ( refer to fireplace installation instructions) • Remove the window, log set and brick set. (refer to fireplace installation instructions) • Shut off gas supply to the fireplace and disconnect the gas line. - Page 3 • Remove the metal between the two cutouts in the side of the linerbox. (Fig.5) • Secure the control mounting bracket to the battery heat shield(see fig 6) • Connect the Molex connector from the fan to the control box, feed the cord set through the left-hand side of the liner box, and then secure the control box and the control heat shield to the mounting bracket ( see fig 7)
-
Page 4: Operation
5. OPERATION The fan is designed for automatic operation using a thermal switch. To operate the fan, press the switch to the left or right from the central off position, the position marked with two dashes being the hi speed, one dash being the lo. The fan will not run until the thermal switch is heated by the fireplace, this takes approx 5 to 10 mins. - Page 5 LIMITED WARRANTY POLICY Miles Industries Ltd. warrants all components of the model 796 circulating fan kit for a period of one year from the date of purchase against defects in materials or workmanship. This warranty covers only the cost of defective parts and applies only to the original consumer purchaser.