Advertisement
4. During operation the optical sensor may become dirty and require cleaning. The following
notification box MAY appear when cleaning is required.
Figure 3: Sensor Obstructed Cleaning Required Message
5. To clean DecapSense™ use compressed air and/or Isopropyl alcohol to clean the decapping
hole in the press and sensor. DO NOT USE SOLVENTS OF ANY KIND TO CLEAN THE SENSOR.
WARNING – cleaning intervals of the Mark 7® DecapSense™ will vary dramatically based upon
many factors. WE SUGGEST CLEANING THE MARK 7® DecapSense™ AS OFTEN AS PRACTICAL
– IT IS UP-TO YOU TO ENSURE THE SENSOR IS CLEAN.
This is a product that is designed to improve the safety of the reloading operation. NEVER RELY
ON THE DecapSense™ SENSOR. You must monitor its use – ALWAYS. Always be close to your
machine and available to stop the machine if it needs to be stopped
Troubleshooting
Refer to the knowledge base section on our website under SUPPORT for troubleshooting articles relating
to setup and operation.
http://www.markvii-loading.com/knowledgebase
Please contact us for technical support
Phone: 1-888-462-7577
Hours: 9:00am-4:30pm, ET, M–F
DECAPSENSE INSTRUCTION MANUAL VERSION 1.1
5
Advertisement
