Hardware Specifications - Cisco Firepower 1010 Hardware Installation Manual

Overview
5

Hardware Specifications

The following table contains hardware specifications for the Firepower 1010.
Table 2: Firepower 1010 Hardware Specifications
Dimensions (H x W x D)
Weight
System power
Temperature
Humidity
Altitude
Acoustic noise
Network
Status of the network ports.
Connection-speed status (S):
• Green, flashing—One flash every three
seconds = 10 Mbps.
• Green, flashing—Two rapid flashes = 100
Mbps.
• Green, flashing—Three rapid flashes = 1000
Mbps.
1.82 x 7.85 x 8.07 inches (4.62 x 19.94 x 20.50 cm)
3 lb (1.36 kg)
30 W
Not including any PoE devices connected to the chassis. 55 W is the maximum
power for the power supply.
Note
Note
Operating: 32 to 104°F (0 to 40°C)
Derate the maximum operating temperature 1.5° C per 1000 ft above sea level.
Nonoperating: -13 to 158°F (-25 to 70°C) maximum altitude is 40,000 ft
Note
Operating: 90%
Nonoperating: 10 to 90%
Operating: 0 to 9843 (3000 m)
Nonoperating: 0 to 15,000 ft (4570 m)
0 dBa
—
PoE+ is first supported in FTD Version 6.5.
Use the power supply (part number 341-100765-01) that shipped with
the chassis. It supports PoE+.
Because the Firepower 1010 has no fan, the internal system temperature
is significantly higher than the operating temperature.
Cisco Firepower 1010 Hardware Installation Guide

Hardware Specifications

11