Cisco Firepower 1010 Hardware Installation Manual page 33

Hide thumbs Also See for Firepower 1010:

Table of Contents

Mount the Chassis

• Three Phillips M3 x 6-mm screws (part number 48-0460-01)

• Two Phillips #6 x 1¼-inch screws (part number 48-2289-01)

• One #8 wall anchor kit with screws (part number 51-4718-01)

Follow these steps to mount your chassis on a wall.

Step 1

Choose an orientation (left-, right-, or rear panel-side up) and a location on the wall for the chassis.

Step 2

Use a pencil, ruler, and level to mark locations for the two mounting screws (#6 x 1¼ inch). You can use the wall-mount

bracket itself to mark either the top holes or the side holes.

Figure 26: Wall-Mount Bracket

Horizontal mounting

Step 3

Attach the wall-mount bracket to the chassis using the three Phillips M3 x 6-mm screws.

Vertical mounting

Cisco Firepower 1010 Hardware Installation Guide

Wall-Mount the Chassis

Table of Contents