Cisco Firepower 1010 Hardware Installation Manual page 48

Install the FIPS Opacity Shield
Figure 37: TELS Placement on the Rear Panel and Bottom of the FIPS Cover
TEL 1 on the rear panel of the chassis
1
3 TEL 3 on the bottom center of the FIPS cover over
the screw
Step 7 Reinstall the chassis in the wall mount if you are using a mount. See
procedure.
Step 8 Attach the power cable to the chassis and connect it to an electrical outlet.
Step 9
Press the power switch on the rear panel.
Step 10 Check the power LED on the front panel. See
indicates that the chassis is powered on.
Step 11
Place the chassis in FIPS mode.
See the following procedures for how to place the chassis in FIPS mode:
• See the "Security Certifications Compliance" chapter in the
Version 6.7
Cisco Firepower 1010 Hardware Installation Guide
44
for the procedure to enable FIPS mode.
TEL 2 on the bottom left of the FIPS cover over the
2
screw
4 TEL 4 on the bottom right of the FIPS cover over the
screw
Wall-Mount the Chassis, on page 28
Status LEDs, on page 8 for a description of the power LED. Solid green
Firepower Management Center Configuration Guide,
Installation, Maintenance, and Upgrade
for the