After Using The Appliance - Siemens VCH6XTRM Instruction Manual

Table of Contents

Advertisement

Charging
!
Caution: Before using the vacuum cleaner for the
first time, the batteries must be charged for at least
6 hours.
3
Fig.
To charge the vacuum cleaner, place it near to a so-
cket. The appliance can be left standing anywhere in
7
the room.
Fig.
Plug the charging cable into the connection at the
rear of the appliance.
Plug the charging cable plug into the socket.
The charging indicator flashes during the charging
process.
Once the battery is fully charged, the charging indi-
cator lights up in blue and no longer flashes.
It is normal for the charging cable and hand vacuum
cleaner to become hot and not a cause for concern.
Battery charging status indicator
4*
Fig.
The battery charging status indicator for the appliance
corresponds to one of the two following variants:
a) The indicator shows the charging status of the battery.
Once the battery is fully charged, the indicator lights
up in blue.
When the indicator flashes, the battery must be re-
charged.
b) The indicator LEDs show the charging status of the
battery.
Battery fully charged
Battery semi-charged
Battery low
When the final LED flashes, the battery must be re-
charged.
Vacuuming
5
Fig.
Move the on/off button in the direction of the arrow.
Controlling the suction level
6
Fig.
To change the suction power, slide the on/off switch to
the desired position:
Power level 1
Vacuuming without the electric brush switched on.
For simple cleaning tasks on hard floors and particu-
larly low operating noise.
The appliance achieves the maximum run time at
this level.
Power level 2
Vacuuming at normal power and with the electric
brush switched on.
For normal cleaning tasks on all floors at an average
run time.
Turbo level
Vacuuming at full power and with the electric brush
switched on.
For particularly demanding cleaning tasks on all sur-
faces (carpets, in particular) and when using an op-
tional accessory. The appliance achieves a shorter
run time at this level.
7
Fig.
During short pauses in vacuuming, the appliance can
be left standing anywhere in the room. To do this, tilt
the vacuum cleaner forwards slightly in the direction
of the nozzle.
!
Caution: When the appliance is left standing, it must
be switched off, because if the brush is turning while
the appliance is standing still, it could cause damage
to the floor covering.
Vacuuming with accessories
8*
Fig.
a) Plug the accessory adapter into the hand vacuum clea-
ner and lock into place.
To release the accessory adapter, press the release
button and pull out the accessory adapter.
b) Fasten the carrying strap to the handle. When doing so,
lay down the appliance; do not rest it on the adapter
or the hose.
9*
Fig.
Fit nozzles as required to the flexible hose with the ac-
cessory adapter handle:
Upholstery nozzle for vacuuming upholstered furni-
ture, curtains, etc.
Crevice nozzle for vacuuming crevices and corners,
etc.

After using the appliance

10
Fig.
Switch off the appliance after vacuuming.
Emptying the dust container
11
Fig.
In order to achieve the best possible vacuuming re-
1
sults, the dust container should be emptied after every
use or, at the latest, when dust at one point in the dust
container has reached the marking.
We recommend that you not fill the dust container bey-
ond the marking, as this leads to considerable soiling
of the filter.
* Depending on model
2
Turbo
11

Advertisement

Table of Contents
loading

Table of Contents