Installation Protocol - ComfortZone RX35 User And Installation Manual

ComfortZone RX35/RX50/RX65

Installation protocol

23
.................................................................................................................
Installer
..................................................................................................................
Address
..................................................................................................................
Zip code / town
..................................................................................................................
Phone No:
Heat pump
Plumber
1.1 Check that the system is clean and / or dirt filter mounted.
1.2 Check that the circulation water system is aerated.
1.3 Check the gauge pressure, 1.0-1.5 Bar
1.4 Check that any shut-off valves in the circulation water system are open.
1.5 UV Pump Speed (Circulation Pump Rate in%)
1.6 Check that the waste water funnel is connected to the floor drain.
Electrician
2.1 Configure the input power limit. (Max power
output).
2.2 Control measures L1, L2 and L3 against zero and ground.
2.3 Check that the heat pump is filled with water. Turn on the main switch
2.4 Check that the heat pump starts up, it takes 5 minutes before the compressor starts.
Ventilation installer
3.1 Check that the exhaust duct is insulated with diffusion-blocked insulation.
3.2 Set the fan speed. Normal. (fan effect) and enter Value.
3.3 Check that air flow measurement is performed, specify air flow l / s.
Responsible installer
4.1 Check that the above points have been reported by the respective installer.
4.2 Make sure that machine settings are complete:
Go to "Advanced settings" / "Basic settings".
- UV heating........................................................................... Underfloor ...
- UV Control method........................................................................ IN......... OUT......... OUT&IN.
- UV Heating curve...........................................................................................................................
- UV Pump speed.................................................................................................................................
- Fan speed.
- Effect limit
Go to "Advanced Settings" / "Corrections".
- TE24, enter the correction value ............................................................................................. ...........
4.3 Check that all the housings thermostats are fully open (indoor control).
4.4 Set the heat pump to the control method
IN. Set the desired room temperature to
35 ° C. Let the heat pump run for about
10-15 minutes.
Check that all radiators and / or floor heating coils are hot. Check that there is
even temperature in all floors and in all rooms. Reset normal values for the
desired room temperature.
.................................
Date
Type:.........................................
Normal...............................................................................................................
....................................................................................................................
.................................................................................................
Responsible installer
Service & Maintenance
.................................................................................................................
Customer
..................................................................................................................
Address
..................................................................................................................
Zip code / town
..................................................................................................................
Phone No:
Nr:........................................................
Seri
Radiator heating.
64
Value OK Sign
---
---
---
---
.........%
---
Value OK Sign
.........W
---
---
---
Value OK Sign
---
.........%
........l/s
Value OK Sign
---
...........
.........%
.........%
.........W
---
---