Control Method Out; Control Method In - ComfortZone RX35 User And Installation Manual

ComfortZone RX35/RX50/RX65
the bar to half its length from the center line.
Save the set value by pressing the knob.
Now you have instructed the heat pump to increase / decrease the heating
curve according to your preference based on the current outdoor temperature.
The pump remembers the setting and adjusts the heating curve each time the
current outdoor temperature is reached.
Fine-tune further if you are not satisfied.
Repeat the procedure at other outdoor temperatures / menu bars if necessary.
Note: If the heat pump's fine tuning is set so that all the bars are close to the
max or min position, this means that the heat curve is incorrectly set. Increase
or decrease the heat curve selection by one unit.

2.6 Control method OUT.

Means that the heating is
controlled by the outdoor
temperature only.
The function is the same as
with OUT & IN control but
without indoor temperature
compensation.

2.7 Control method IN.

Means that the heat pump is controlled by your indoor temperature only.
You set your desired indoor temperature and the heat pump ensures
that this temperature is reached.
With IN control method, the
indoor temperature is
controlled exclusively by the
indoor temperature.
Since the air comes from
different places in the house,
you have an average
temperature from all of your
exhaust air devices, or if the
external indoor sensor is
used, the temperature at
where it is mounted.
The heat pump in this case is the entire house's thermostat. All room
thermostats in accommodation rooms, i.e. living room, TV room,
kitchen etc. shall have the thermostats set to maximum position, i.e. be
fully open.
8
Operating instructions