Unit Identification (Uid) Button; Power On/Standby Button - HP StorageWorks D2700 User Manual

Hide thumbs Also See for StorageWorks D2700:

Table of Contents

Unit identification (UID) button

The unit identification (UID) button helps locate an enclosure and its components. When the UID button

is activated, the UID on the front and rear of the enclosure are illuminated.

NOTE:

A remote session from the management utility can also illuminate the UID.

•

To turn on the UID light, press the UID button. The UID light on the front and the rear of the enclosure

will illuminate solid blue. (The UID on cascaded storage enclosures are not illuminated.)

•

To turn off an illuminated UID light, press the UID button. The UID light on the front and the rear

of the enclosure will turn off.

The power on/standby button applies either full or partial power to the enclosure chassis.

•

To initially power on the enclosure, press and hold the on/standby button for a few seconds, until

the LEDs begin to illuminate.

•

To place an enclosure in standby, press and hold the on standby button for a few seconds, until

the on/standby LED changes to amber.

NOTE:

System power to the disk enclosure does not completely shut off with the power on/standby button.

The standby position removes power from most of the electronics and components, but portions of

the power supply and some internal circuitry remain active. To completely remove power from the

system, disconnect all power cords from the device.

D2600/D2700 Disk Enclosure User Guide

Table of Contents

Storageworks d2600