Table of Contents
Advertisement
[8PWR] Sensors Plugin
Sensors 1-Wire
Sensors 1-Wire
(Temperature 1-wire, (THS), 2m and Humidity sensor
RJ12, allowed to use extension cords or splitters. Maximum cable length 1-Wire network is limited to 50 meters.
Sensors of Dry Contact Type
Dry contact sensors are door opening sensors, buttons and other sensors, with a mechanism of work based on
opening/closing a conductor. A sensor is connected with two wires to an IO line of a device according to the table
(an order of plugging wires does not matter).
Sensor Flex
First wire
Second wire
Important! Sensors of a dry contact type, a
IO lines of a device. You can plug any four sensors out of this set.
Important! A corresponding IO line should be set to an input mode in settings of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help
of flat cable extenders of
independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.
Leakage Sensors
A leakage sensor is connected by a four-wire line according to the table.
Sensor Flex
Green
Yellow (White)
Black
supply voltage
RC-4 sensor, which are sequentially plugged one into another. Or it can be done
Red
[ENG] NetPing 8/PWR-220 v4/SMS, User guide -[8PWR] Sensors Plugin
1-wire) connected to the connectors 1W plugs
NetPing 8/PWR-220 v4/SMS Terminal
One of IO lines – 1/2/3/4
sensor, a leakage sensor, and others are plugged to
NetPing 8/PWR-220 v4/SMS Terminal
One of IO lines – 1/2/3/4
G
2
. Maximum allowable length of a
G
+
G
[8PWR] Sensors Plugin
–
Advertisement
Table of Contents
