External Connections - BRUEL & KJAER VIBROCONTROL 1800 Series Instructions Manual

Brüel & Kjær Vibro │ Instruction VC-1800 Series
8.1.5

External Connections

DC supply:
The VC-1801 relay module is supplied with the necessary voltage through the adjacent VC-18xx
module via the 5-pin DIN-rail connection. A 5-pin DIN-rail connection is in the standard
configuration as a standard feature with every VC-18xx and VC-1801 relay module.
WARNING!
VIBROCONTROL 18xx and VC-1801 devices can be damaged by a "HOT-Swap."
The VIBROCONTROL 18xx must be disconnected from the main power supply (+24 VDC) first.
•
Turn off the supply voltage
•
Connect the VIBROCONTROL 18xx and the VC-1801 with each other using the DIN-rail plug
connection
•
Turn on the power supply again
Data:
The data flow between the VIBROCONTROL 18xx and the VC-1801 relay module is (also) via the
5-pin DIN-rail bus connector.
© Brüel & Kjær Vibro ● C106834.002 / V06 ●
Technical alterations reserved!
Extension Modules for VIBROCONTROL
UNRESTRICTED DOCUMENT
EN
1850/1860/70
Page 57 of 110