New Holland T4.75 Service Manual page 67

22. Refit the bracket (2) supporting the cab connectors,
cab power and cup filter (3). Connect the pipe that
joins the latter to the mechanical priming pump on the
sediment filter.
23. On the left-hand side, connect the cab power cable
connector (1). Put the connector on the maxi fuse box
and lock with clamps.
24. Return the main engine cable (3) back into position.
Connect the sensors and switches located on the en-
gine, the connectors (4) on the controller (5) and on
the maxi fuse compartment. Fasten the wiring with
clamps.
25. Lay out the FTP interface - engine cable (1) on the
machine. Reconnect the various connections (2). Se-
cure the wiring with clamps.
26. Refit the starter motor (2). Then connect the ground
cable of the engine and battery system. Secure the
ground cable with the bolt (3).
27. On the right-hand side, reconnect the battery positive
cable and the wirings to the starter motor, battery cut-
off switch and alternator. Refit the shroud (1) on the
starter motor (2).
28. Refit the two supply and return lines to the cab heater
(1) and the pipe (3) inserted on the lower sleeve com-
ing from the expansion tank. Refit the upper and lower
sleeves (4) of the engine radiator connection. Secure
the straps and clamps tightening the pipes.
Engine - Engine and crankcase
47803847 15/12/2014
10.1 [10.001] / 38
13
WLAPL4S10C139A
14
WLAPL4S10C137A
15
WLAPL4S10C135A
16
MOIL13TR01739AB