Settings of the Printer Driver
Set the output port
When you connect the PC with the plotter via USB interface cable
1
Install "Mimaki driver" in your PC.
• The "Mimaki driver" is included in the manual CD attached to APC-130.
Otherwise download the Mimaki driver, check "Driver / Utility" on the download page at Mimaki
Engineering (http://eng.mimaki.co.jp/download/).
2
Connect your PC with plotter with a USB cable and turn on the
power.
3
Referring to P.8, select the "Ports" tab.
4
Select output port.
• When you connect multiple plotters with the PC, select
different ports.
• When you connect multiple plotters (same
14
device type) with the PC, set different device
No. for each plotter in "USB device No.
setting" of the plotter. If you set the same
device No. to multiple plotters, the ports
cannot be displayed.