Camshaft Journal Diameter - New Holland 6010 Service Manual

Camshaft
Camshaft bushing O.D.
• Front
• Intermediate
• Rear
Bushing interference fit in housing
Camshaft bushing fitted I.D after reaming:
‐ Front
‐ Intermediate
‐ Rear

Camshaft journal diameter:

‐ Front
‐Intermediate
‐ Rear
Camshaft journal clearance in bushing
Maximum wear clearance
Camshaft end float (thrust plate to associated seat in camshaft)
Tappets
Tappet O.D
Tappet clearance in housing on engine block
Maximum wear clearance
Tappet oversize
Rocker bore diameter
Rocker shaft diameter
Rocker shaft clearance in bracket
maximum wear clearance
Rocker spacer spring length:
‐ Free
under load 4.7 - 5.3 kg
Valves, guides and springs
Valve head diameter inlet
Exhaust
Valve stem diameter
Valve face angle: inlet
Exhaust
Tappet clearance
Engine inlet
Exhaust (cold)
Cam lift: inlet
exhaust
Valve lift: inlet
Exhaust
Lubrication system
Oil pump
Oil pump drive ratio
Oil pressure
Relief valve crack‐off setting .
Assembly. clearance between shaft and bushing oil pump drive
Shaft clearance in driven gear
Gear backlash
Gear radial clearance in pump housing
Drive and driven gear width
Engine - Engine and crankcase
47969433 28/11/2016
10.1 [10.001] / 6
54.875 - 54.930 mm
54.375 - 54.430 mm
53.875 - 53.930 mm
0.070 - 0.150 mm
51.080 - 51.130 mm
50.580 - 50.630 mm
50.080 - 50.130 mm
50.970 - 51.000 mm
50.470 - 50.500 mm
49.970 - 50.000 mm
0.080 - 0.160 mm
0.20 mm
0.070 - 0.220 mm
14.950 - 14.970 mm
0.030 - 0.068 mm
0.15 mm
0.1‐ ‐ ‐ 0.2‐ ‐ ‐ 0.3 mm
18.016 - 18.034 mm
17.982 - 18.000 mm
0.016 - 0.052 mm
0.15 mm
59.5 mm
44 mm
45.300 - 45.500 mm
40.75 - 41.25 mm
Inlet- 7.985 - 8.000 mm
Exhaust 7.975 - 7.990 mm
60 o 30'±7 ' °
45 o 30±77' °
0.45 °
0.30±0.05 mm
0.30±0.05 mm
5.889 mm
6.127 mm
10.445 mm
10.868 mm
Gear, crankshaft driven
1.27:1
Rated – 3 - 4.5 bar
Peak torque – 2.5 - 3.5 bar
3.6 bar
0.016 - 0.070 mm
0.016 - 0.054 mm
0.100 mm
0.015 - 0.067 mm
15.973 - 16.000 mm