Cub Cadet WO STAGE SNOW THROWER 930 SWE Operator's Manual page 21

11. If also replacing the drive belt, proceed to the "Drive
Belt" instruction. If not, reposition the transmission
frame back onto the auger housing. Install the auger
belt on the engine pulley, re-connect the auger cable
"Z" fitting and auger idler rod ferrule to the brake
bracket. Reposition and secure the engine pulley belt
guard, and re-install the belt cover.
Make sure to remove the piece of wood blocking the
NOTE:
impeller.
Check the auger drive belt adjustment. With the auger
clutch lever in the disengaged position, the top surface of
the new belt should be even with the outside diameter of
the pulley.
To adjust, disconnect ferrule from brake bracket assembly.
Thread ferrule in (towards idler) to increase tension on belt,
or out to decrease belt tension.
The brake puck must always be firmly seated in the
NOTE:
pulley groove when auger control is disengaged.
Repeat the "Testing Auger Drive
CAUTION:
Control" from the Assembly and Set-up section
before operating the snow thrower.
Drive Belt Replacement
If not already done, remove the auger drive belt from the
front pulley of the engine double pulley. Refer to "Auger
Belt Replacement" instructions in the previous sub-section.
1. Pull the idler pulley away from the backside of the drive
belt to relieve the tension and slip the drive belt off the
idler pulley. Carefully release the idler pulley. See Fig. 7-8.
Figure 7-8
2. Roll the drive belt off the lower drive pulley and then
remove the belt from the engine pulley.
3. Install the new belt on the pulleys in the reverse order and re-
tension with the idler pulley.
3
1b
1a
2
4. Reassemble by performing the previous steps in the
opposite order and manner of removal.
Changing Friction Wheel
The rubber on the friction wheel is subject to wear and
should be checked periodically. Replace the friction wheel
if any signs of wear or cracking are found.
1. Drain the gasoline from the snow thrower, or run the fuel
tank dry to prevent a hazardous situation.
2. Tip the snow thrower up and forward, so that it rests on
the housing.
3. Remove screws from the frame cover underneath the
snow thrower, as seen in Figure 7-9. Remove the right
wheels from the axle.
Figure 7-9
4. Using a 3/4" wrench, hold the hex shaft and remove the
hex screw and belleville washer and bearing from left
side of the frame. Refer to Figure 7-10.
Remove Hex Screw
& Belleville Washer
Hex Shaft
Figure 7-10
5. Holding the friction wheel assembly, slide the hex shaft
out of the right side of the frame. The spacer on the left
side of the hex shaft will fall and the sprocket should
remain hanging lose in the chain.
Friction Wheel
Assembly
Slide Hex
Shaft Out
Right Side
s 7 — s 21
ectiOn ervice