Cub Cadet WO STAGE SNOW THROWER 930 SWE Operator's Manual page 20

4. From both sides of the frame assembly, use a 1/2" wrench
to remove the three hex tap screws securing the
transmission frame to the auger housing assembly.
Refer to Figure 7-1.
Do not remove the lower hex flange lock nut
NOTE:
on each side.
5. Place a block of wood underneath the auger housing as
shown in Figure 7-6 and separate auger housing from
the transmission frame by tilting the housing forward
and pulling up the handles.
6. Block the impeller with a piece of wood the prevent from
spinning and use a 1/2" wrench to remove the hex
screw and flat washer from the center of the auger
input shaft and auger pulley adapter. Refer to "A" in
Figure 7-7.
20 s 7— s
ectiOn ervice
Figure 7-5
Figure 7-6
A
Figure 7-7
7. Lift the brake bracket assembly out of the pulley groove
(B) and slide the pulley assembly off the posts of the
auger pulley adapter (C) to remove the old belt. Refer to
Figure 7-7.
The pulley adapter may slide off the auger
NOTE:
input shaft when removing the pulley. Use extra
caution to ensure the adapter does not fall and get
damaged when removing the pulley.
8. Place the new auger belt in the V-groove of the auger
pulley and place the pulley with the belt inside the belt
keepers.
9. Turn the pulley as necessary to align its three slots
approximately with the posts of the pulley adapter, then
move the brake bracket assembly away from the input
shaft. While aligning the pulley slots and adapter
posts, push the auger pulley fully onto the adapter.
Refer to Figure 7-7.
If the pulley adapter was removed with the
NOTE:
pulley, align the splines of the pulley adapter and
auger input shaft, and push the pulley and adapter
onto the input shaft. Refer to Figure 7-7.
9. Slide the washer onto the hex screw removed earlier and
apply Loctite 262 to the threads of the hex screw.
10. Insert the hex screw through the pulley assembly and into
the threads of the input shaft. Torque the hex screw to
250-325 in. /lbs. to secure the auger pulley assembly
on the input shaft.
Adapter Post
B
C
Pulley Slot
Belt Keeper